available (C-suffix and I-suffix types), ranging from the low-cost TLC (10 mV) . In the low-bias mode, the TLC features low offset voltage drift, high input. Texas Instruments TLC Series Operational Amplifiers – Op Amps are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for Texas. TLC Operational Amplifiers – Op Amps are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for TLC Operational Amplifiers .

Author: Tat Tak
Country: Iceland
Language: English (Spanish)
Genre: Software
Published (Last): 18 April 2004
Pages: 481
PDF File Size: 13.33 Mb
ePub File Size: 14.53 Mb
ISBN: 906-8-58511-206-1
Downloads: 13042
Price: Free* [*Free Regsitration Required]
Uploader: Kajizshura

These devices use Texas Instruments silicon-gate LinCMOS technology, which provides offset voltage stability far exceeding the stability available with conventional metal-gate processes.

When the output tl271 power amplifier shows a potential which differs from GND, a current is flowing through R25 and C3 is charged. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right.

Go to Support forums. Do you have another question?

TLC Datasheet pdf – LinCMOS(TM) Programmable Low-Power Operational Amplifier – Texas Instruments

Tlf271 be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet. This thread has been locked. The mV you measure is directly the output signal of TLC I don’t think, that this rather low input offset voltage must be trimmed to zero?

TOP Related Articles  BC807 40 EPUB

Apr 22, 3: As the bases and emitters of both transistors are connected to each other, only one transistor can be open at a time. Do you have another question? Typically delay varies only 3 ns for overdrive variations to mV. It is suitable for stereo and bridge amplifier application of radio cassette tape recorders.

In single-supply applications, the medium-bias mode necessitates using a voltage divider as indicated in Figure 1.

TLC , Tube TLC; R̦hre TLC ID, IC РIntegrated

Apr 21, 7: In the high-bias mode, the TLC series features ltc271 offset voltage drift, high input impedance, and low noise. The DC servo works as follows: The device has been optimized for greater speed, input impedance and fan-out, and lower input offset voltage. So, the output voltage of TLC has not t,c271 be trimmed to mV, but is tuned to this voltage automatically when the DC servo loop stabilizes and the regulation of output voltage comes to rest.


Use of the information on this site may require a license from a third party, or a license from TI.

It sounds you’re asking if ltc271 a way to program the input offset voltage so you can trim the output voltage to 0V. Ask a new question Ask a new question Cancel.

Well, I think that the supply voltages are much higher than intended? Apr 22, 1: Single, Dual, Quad, 1.

I don’t think that T15 and Tl2c71 have to be matched parts. They should be at 0V, or at least very close to 0V. In reply to mike Downer: Add R suffix to the device type e.

It has optically isolated input and output ports as well as input and output power monitoring. All postings and use of the content on toc271 site are subject to the Terms of Use of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Terms of Use of this site.

Access Denied

Are the tlc2271 measuring points of quad ok? Ask a new question Ask a new question Cancel. Unity-gain bandwidth is typically greater than 1 MHz.