Analog Devices Inc. LT Series LED Lighting Drivers are available at Mouser Electronics. Mouser offers inventory, pricing, & datasheets for Analog Devices. 11 May Cheap driver led, Buy Quality driver led dc dc directly from China driver dc Suppliers: LTES6 LT – Constant-Current DC/DC LED. Yesterday evening (CET) I’ve built my newest DC-DC converter with the LT chip from Linear Technology with a hand drawn and etched pc.
|Published (Last):||7 November 2011|
|PDF File Size:||3.15 Mb|
|ePub File Size:||7.28 Mb|
|Price:||Free* [*Free Regsitration Required]|
In Canada I don’t know a distributor but think there must be also several ones. If you could try this in your test, that would be great. I hope you don’t mind, but it should also give others some more useful data as well.
Looks like you’ve got a buildable design. The model has been scheduled for obsolescence, but may still be purchased for lt1923 limited time.
Here are some more results with my ver1 board which will give you an idea how the LT works in your configuration. The various ranges specified are as follows: With such a load of 8 Nichias driven with only 20mA the result with this LT booster would be for sure much better. Hey, that’s great efficiency! Model Package Pins Temp. I’m not sure of the value in dimming, although it would extend the battery life.
Results 1 to 25 of In this case you could compare the above published results with your configuration with two chains of LEDs in parallel. I used it because the inductor has only 6. Click on the link in the section below to download a demonstration circuit. BTW, which circuit configuration and component values are you using? I already designed a smaller one but didn’t test it up to now and therefore I don’t know how it works. Here the first results: IMO there a a lot of better chips to drive the LS eg.
Using 8 Nichias driven with only 20mA would produce about the same brightness as 5 Nichias driven with 38mA but with kt1932 lower power consumption. That’s interesting you got such good efficiency numbers. l1t932
This helps to avoid some main design problems. I will do some more tests to learn more about it and then poosibly try to improve it a bit. The product is appropriate for new designs but newer alternatives may exist. The specific part is obsolete and no longer available. Most orders ship within 48 hours of this date. It is important to lt132 the scheduled dock date on the order entry screen.
LT Datasheet pdf – Constant-Current DC/DC LED Driver in ThinSOT – Linear Technology
Have you done any experimenting in this manner? Lt1923 as I already pointed out it is not a booster for the LS and it was never my intention to do it with this chip.
If I would reduce this current to the recommanded 20mA the booster would have driven the Nichias for many hours with the full brightness. The Nichias usually dont require ultra low ripple voltage operating 40ma or less. Transit times from these sites may vary. That stays about constant, then the current drops with the battery voltage as they wear down. An Evaluation Board is a board engineered to show lt193 performance of the model, the part is included on the board.
A smaller inductor should fit very well on the board as I have considered this. Other models listed in the table may still be available if they have a status that is not obsolete. Also, dont let the higher price of low ESR caps fool you; they should only be used when low ripple is needed.
With this first prototype I could already make a fine mod. Ok, how does a current controlled booster work?
Too bad there isnt a way to change the output transistor; that’s internal also. Each chip has its limitation. Ltt1932 if you are going to design your own board keep the output pin of the LT, the inductor, the schottky diode and the output cap very close together with very short connections between them.